From: istong@stong.org
Date: Fri Jun 03 2005 - 16:52:11 GMT-3
Hi,
If there are ATM switches in the middle you can have
different pvcs on each end and use the sane subnet on each
end. I.E. exactly what you mentioned below. However if you
don't have the atm switch in the middle that matches up
those different pvcs then you would have to use the same
pvcs on each end based on my knowledge.
Thanks,
Ian
www.ccie4u.com
Rack Rentals and Lab Scenarios starting at only $12
> Hi all, is it possible to have two ATM PVCs on the same IP
> subnet? eg., R1 pvc 0/100 (10.10.10.1/30)and R2 pvc 1/101
> (10.10.10.2/30). Will this work? I've tried to no avail
> unless I configure the same VPI/VCI pairs on both ends of
> the PVC. You help will be appreciated.
> __________________________________________________________
> ___________ For super low premiums, click here
> http://www.dialdirect.co.za/quote
>
> __________________________________________________________
> _____________ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Ian Stong
http://www.ccie4u.com
"Rack Rentals and Lab Scenarios starting at only $20"
support@ccie4u.com
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3