From: Sumit (sumit.kumar@comcast.net)
Date: Fri Jun 03 2005 - 11:35:40 GMT-3
Thinking about this:
This can be dome using PPPoFr, configure PPPoFr between R1 and R2 and use
MD5 authentication, and use no authentication on physical frame interfaces
between R1 and R3.
Use IP unnumbered <se0/0- frame interface > for virtual-temp.
Should work
----- Original Message -----
From: "CCIE Welcome" <ccie_sky@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, May 31, 2005 6:48 PM
Subject: OSPF Authentication
> Hi,
> I have Hub and 2 spokes as shown below
>
> -----------------(s0)R2
> R1(s0.1 multipoint) |
> -----------------(s0)R3
>
> How can i configure ospf authentication (MD5) between R1 and R2 only?
> I've configured it as shown below and R1&R2 are working fine but R3
doesn't work?
> can anyone help me?
>
> R1
> ===
> interface serial 0.1
> ip ospf authentication message-digest
> ip ospf message-digest-key 1 md5 cisco
> R2
> ---
> interface serial 0
> ip ospf authentication message-digest
> ip ospf message-digest-key 1 md5 cisco
>
> Regards,
> Ronaldo
>
>
>
> ---------------------------------
> Do You Yahoo!?
> Yahoo! Small Business - Try our new Resources site!
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3