From: Chris Aguillo (ccaguillo1@hotpop.com)
Date: Tue May 31 2005 - 06:09:52 GMT-3
Hi,
Basically, I have two active internet connections from my router.
I have a static route 0.0.0.0 0.0.0.0 via S0 for the general internet. I
wanted my S1 for internet access for specific ip address coming from the
LAN and other internet user will be via my S0.
I used PBR to do this but when there is an intended traffic via S1, it
is sending in load balancing starting in S0 and then S1.
Or am I using the wrong method. My goal is to route all traffic received
from Gi0/0 to/from Se0/0/0 and Gi0/1 to/from Se0/1/0.
Is there any workaround for this?
Thanks for the help
my config below
interface GigabitEthernet0/0
description FROM_NET1
ip address 172.17.17.10 255.255.255.0
duplex full
interface GigabitEthernet0/1
description FROM_NET2
ip address 192.168.5.10 255.255.255.0
ip access-group 1 in
ip policy route-map FI-INTERNET
interface Serial0/0/0
description INTERNET_1
ip address 222.42.161.74 255.255.255.252
interface Serial0/1/0
description ITERNET_2
ip address 292.168.242.18 255.255.255.252
ip classless
ip route 0.0.0.0 0.0.0.0 222.42.161.73
access-list 1 permit 192.168.5.0 0.0.0.255 log
route-map FI-INTERNET permit 10
match ip address 1
set interface Serial0/1/0
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:12:03 GMT-3