From: Steve Ohnmacht (ohnmacht@gmail.com)
Date: Fri May 13 2005 - 16:11:10 GMT-3
Not sure if sh vlan will show fa0/1 bound to both 100 and/or 100.
Based off the config I would assume that you should see fa0/1 assigned
to vlan 100 from the sh vlan output... That's something I will need to
check myself... thanks....
On 5/13/05, Joiner, Shane <SJoiner@seton.org> wrote:
> With the following interface configuration:
>
> Int f0/1
> switchport access vlan 100
> switchport voice vlan 101
> switchport priority extend cos 1
> mls qos trust device cisco-phone
> mls qos trust cos
> no mdix auto
> auto qos voip cisco-phone
> spanning-tree portfast
>
> How can I tell if the device plugged into the port is using vlan 100 or
> 101?
>
> I can perform a show cdp neighbors and see where phones are attached.
> If I perform show interface status then it show the port is in vlan 100.
> Even spanning tree shows each port participating in both vlans.
>
> Thanks,
> Shane
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- -so
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:58 GMT-3