From: Joiner, Shane (SJoiner@seton.org)
Date: Fri May 13 2005 - 16:05:06 GMT-3
With the following interface configuration:
Int f0/1
switchport access vlan 100
switchport voice vlan 101
switchport priority extend cos 1
mls qos trust device cisco-phone
mls qos trust cos
no mdix auto
auto qos voip cisco-phone
spanning-tree portfast
How can I tell if the device plugged into the port is using vlan 100 or
101?
I can perform a show cdp neighbors and see where phones are attached.
If I perform show interface status then it show the port is in vlan 100.
Even spanning tree shows each port participating in both vlans.
Thanks,
Shane
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:58 GMT-3