From: James Matrisciano (jmatrisciano@kenttech.com)
Date: Thu May 12 2005 - 09:47:06 GMT-3
Change the interface to match, just like in OPSF, both sides must be the
saem (multipoint...point-to-point). Use the "isis network
point-to-point" interface command.
http://cisco.com/en/US/products/ps6350/products_configuration_guide_chap
ter09186a00804556b8.html#wp1025127
jm
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
kuldip singh
Sent: Thursday, May 12, 2005 8:17 AM
To: Marakalas
Cc: ccielab@groupstudy.com
Subject: Re: ISIS over Frame Relay
Hi Maraklas,
I never got ISIS to work over point-to-point link.
But you probably
need to change the point-to-point link to multipoint or run it over GRE
tunnel.
On 5/12/05, Marakalas <marakalas@yahoo.com> wrote:
> Hi guys, I'm busy configuring ISIS across a F/R cloud
> in the lab environment. However, I'm getting
> encapsulation errors when debugging. What I did was to
> configure frame-relay map clns 412 broadcast. This is
> on the multipoint interfaces. What should be
> configured on the point-to-point interfaces to have
> ISIS working between two neighbours?
>
> Thanks in advance.
>
> Yahoo! Mail
> Stay connected, organized, and protected. Take the tour:
> http://tour.mail.yahoo.com/mailtour.html
>
>
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:57 GMT-3