dlsw remote-peer 0 tcp x.y.z.k cost x

From: mani poopal (mani_ccie@yahoo.com)
Date: Sun May 08 2005 - 23:05:27 GMT-3

• Next message: Long Kwok: "Internetworkexpert member page down ??"
• Previous message: Long Kwok: "RE: Limiting eigrp packets out a Given set of interfaces"
• Next in thread: san: "Re: dlsw remote-peer 0 tcp x.y.z.k cost x"
• Maybe reply: san: "Re: dlsw remote-peer 0 tcp x.y.z.k cost x"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Guys,
 
In dlsw what is the reason of cost command. I know default cost is 3 and lower cost is preferred. Pls look at following configs.
 
Hub router config:(R3 is hub)
dlsw remote-peer 0 tcp 15.15.2.2 cost 1-->to R1
dlsw remote-peer 0 tcp 15.15.2.2 cost 2-->to R2.
 
Can this config be given on a spoke router and pushed to the hub. In the above config the configurations are given on the hub router..
Will the hub maintains connectivity with both spokes(and prefer R1) or only with R1 and disconnect with R2
 
I took this sample config from IEWB
 
any help is appreciated.
 
thanks
 
Mani

B.ENG,A+,CCNA,CCNP,CCNP-VOICE, CSS1,CNA,MCSE
(416)431 9929
MANI_CCIE@YAHOO.COM
                
---------------------------------
Discover Yahoo!
 Have fun online with music videos, cool games, IM & more. Check it out!

• Next message: Long Kwok: "Internetworkexpert member page down ??"
• Previous message: Long Kwok: "RE: Limiting eigrp packets out a Given set of interfaces"
• Next in thread: san: "Re: dlsw remote-peer 0 tcp x.y.z.k cost x"
• Maybe reply: san: "Re: dlsw remote-peer 0 tcp x.y.z.k cost x"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:57 GMT-3