From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Thu May 05 2005 - 12:24:37 GMT-3
Use exec callback to accomplish this. You can configure it to callback
a specific number once authentication has occurred:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fdial_c/fnsprt10/dafascal.htm#wp1001053
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of W
> Walla
> Sent: Thursday, May 05, 2005 9:31 AM
> To: ccielab@groupstudy.com
> Subject: Callback from AUX/Modem
>
> Hello-
> I have successfully set up out of band access for one of my remote
> routers.
> However, after I have successfully dialed in across my analog line
from a
> hyperterm session, into the router's aux interface, I would like for
it to
> call only my phone number back (where my laptop is.) I would like to
have
> only that number available for call back. Ithe router I am using is a
> brand
> new 1841. Anyone know how to make this part happen. Like I said I can
> already call the router and put config's on it via analog line into
the
> AUX...
> Thanks!
> fishcca@hotmail.com
>
> _________________________________________________________________
> Dont just search. Find. Check out the new MSN Search!
> http://search.msn.click-url.com/go/onm00200636ave/direct/01/
>
>
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:56 GMT-3