From: Jeff Kesemeyer (groupstudy@bradshawlabs.com)
Date: Thu May 05 2005 - 10:25:42 GMT-3
When you use the map command with frame, you can disable arp (no frame-relay
inverse-arp) and this will remove any unwanted dlci's.
Jeff Kesemeyer
CCNP, CCDP, MCSE, CNE
www.bradshawlabs.com
"Your CCIE Rack Rental Source"
On 5/5/05 8:54 AM, "Frank Center" <ccahoon@maine.rr.com> wrote:
> What is the best way to block a DLCI?
>
> When configuring OSPF different area's over the Frame-Relay links, in my lab I
> have noticed that the broadcast key word in my "frame-relay map ip X.X.X.X
> DLCI broadcast" statement sends the hellos out all DLCI's. I'm getting
> "Received invalid packet: mismatch area ID" error. I can fix this by removing
> the dlci from my Frame-Relay router but looking for best way to filter at the
> router interface. I think there is a command that can ignore the dlci,
>
> Any suggestions?
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:56 GMT-3