From: Ken Bartlinski (kenbar3@gmail.com)
Date: Thu May 05 2005 - 10:43:44 GMT-3
Frank,
This error message sounds like the prompt you would get if there is a
problem with your virtual link configuration under ospf.
Ken
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Frank Center
Sent: Thursday, May 05, 2005 7:55 AM
To: Cisco certification
Subject: removing a Frame Relay DLCI
What is the best way to block a DLCI?
When configuring OSPF different area's over the Frame-Relay links, in my lab
I
have noticed that the broadcast key word in my "frame-relay map ip X.X.X.X
DLCI broadcast" statement sends the hellos out all DLCI's. I'm getting
"Received invalid packet: mismatch area ID" error. I can fix this by
removing
the dlci from my Frame-Relay router but looking for best way to filter at
the
router interface. I think there is a command that can ignore the dlci,
Any suggestions?
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:56 GMT-3