From: George Cassels \(gcassels\) (gcassels@cisco.com)
Date: Wed Apr 27 2005 - 12:34:05 GMT-3
Ok Sean to be honest I can not be sure, but I think that it is because
of the non-broadcast network type. If you did this same config with
point-to-point or point to multipoint network type I think it would work
without any issues. I have not verified this though. So because of the
non-broadcast nature of the frame-relay interface with the neighbor
statement being on the router with both keys the router with only one
key transmissions are never received at the router with two keys. By
putting the neighbor statement on the router with only one key it allows
that routers transmissions to be received by the router with two keys
allowing it to see that its neighbor only has the capability to use key
1 and not its youngest key which in this case is key 2. Lots of theory
here and no real hard facts though.
Anyone else have any theories?
George
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:09 GMT-3