From: gladston@br.ibm.com
Date: Thu Apr 21 2005 - 14:06:59 GMT-3
Rollover key works fine before reloading. After reloading R4 tries to authenticate using key 1 and 2 but adjacency does not go up. If I remove the second key, it establishes the adjacency.
If I configure neighbor statement on R1, adjacency goes up.
Network type is non-broadcast.
Have you seem this behavior?
R4
interface Serial0/0
ip address 142.20.14.4 255.255.255.0
ip pim sparse-dense-mode
encapsulation frame-relay
ip ospf message-digest-key 1 md5 cisco
ip ospf message-digest-key 2 md5 ccie
R4
router-id 142.20.4.1
log-adjacency-changes
area 112 authentication message-digest
area 113 authentication message-digest
redistribute connected subnets route-map connected->ospf
network 142.20.4.0 0.0.0.255 area 112
network 142.20.14.0 0.0.0.255 area 112
network 142.20.45.4 0.0.0.3 area 113
neighbor 142.20.14.1
R1
router ospf 1
router-id 142.20.1.1
log-adjacency-changes
area 0 authentication
area 112 authentication message-digest
redistribute rip subnets
network 142.20.1.0 0.0.0.255 area 0
network 142.20.14.0 0.0.0.255 area 112
network 142.20.125.0 0.0.0.31 area 0
R1
interface Serial0/0.14 multipoint
ip address 142.20.14.1 255.255.255.0
ip pim sparse-dense-mode
ip ospf message-digest-key 1 md5 cisco
ip ospf priority 0
ipv6 address 2001::1/64
frame-relay map ip 142.20.1.4 104 broadcast
frame-relay map ip 142.20.14.4 104 broadcast
Rack2R4#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.2(15)T5
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:05 GMT-3