From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Mon Apr 25 2005 - 21:15:08 GMT-3
Disregard my last.
I found a reboot of the router clears the problem.
Now, I just need to figure out what was stopping the config from taking.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Tony
Schaffran
Sent: Monday, April 25, 2005 5:04 PM
To: ccielab@groupstudy.com
Subject: Route-map problem
I have a 3640 running 12.2.15T13 Enterprise Plus
I cannot seem to get the set command in a route-map to take.
After I issue the command, when I show run, it is not there.
Has anyone come across this? Is this normal?
The set command does take on my 7500 running the same version.
Thank you for any replies.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:09 GMT-3