Route-map problem

From: Tony Schaffran (tschaffran@cconlinelabs.com)
Date: Mon Apr 25 2005 - 21:03:51 GMT-3

• Next message: Dennis J. Hartmann: "RE: QoS - reserve"
• Previous message: ccie2be: "QoS - reserve"
• Next in thread: Tony Schaffran: "RE: Route-map problem"
• Maybe reply: Tony Schaffran: "RE: Route-map problem"
• Maybe reply: George Cassels \(gcassels\): "RE: Route-map problem"
• Maybe reply: Tony Schaffran: "RE: Route-map problem"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I have a 3640 running 12.2.15T13 Enterprise Plus

I cannot seem to get the set command in a route-map to take.

After I issue the command, when I show run, it is not there.

Has anyone come across this? Is this normal?

The set command does take on my 7500 running the same version.

Thank you for any replies.

Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
 
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.

• Next message: Dennis J. Hartmann: "RE: QoS - reserve"
• Previous message: ccie2be: "QoS - reserve"
• Next in thread: Tony Schaffran: "RE: Route-map problem"
• Maybe reply: Tony Schaffran: "RE: Route-map problem"
• Maybe reply: George Cassels \(gcassels\): "RE: Route-map problem"
• Maybe reply: Tony Schaffran: "RE: Route-map problem"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:09 GMT-3