From: Ken Bartlinski (kenbar3@gmail.com)
Date: Wed Apr 20 2005 - 14:28:12 GMT-3
Dennis,
You do not have to turn off DTP. You just use the "switchport trunk
encapsulation dot1q" command on the port in question to achieve this goal.
If you further wish to force the port to only trunk, turn off DTP using the
"switchport mode trunk" command.
Ken
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Dennis J. Hartmann
Sent: Wednesday, April 20, 2005 12:14 PM
To: ccielab@groupstudy.com
Subject: Switchport nonegotiate / DTP
If I'm required to statically set all trunk ports to dot1q, I'll be
turning off DTP with the switchport nonegotiate command.
I didn't notice this in the NMC solutions. Any ideas?
Sincerely,
Dennis J. Hartmann
White Pine Communications
CCSI#23402/CCIP/CCNP/CCDP/CCNA/CCDA
Cisco IP Voice Support & Design Specialist
Cisco Optical, VPN & IDS Specialist
MCSE
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:04 GMT-3