RE: Voice Gateway Q

From: Richard Dumoulin (Richard.Dumoulin@vanco.fr)
Date: Sat Apr 09 2005 - 17:33:44 GMT-3

• Next message: Brian Dennis: "RE: multi parallel pvc's and bridging"
• Previous message: Daniel O'Sheedy: "Re: IE WB2: How to test Backup Interface?"
• Maybe in reply to: David Duncon: "Voice Gateway Q"
• Next in thread: David Duncon: "RE: Voice Gateway Q"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Clear interface is not the recommended way to disconnect an isdn call
because it is too aggressive. The provider switch might not know of the
disconnect and you might end up with a frozen channel.
On the other hand isdn disconnect agrees with the isdn switch to disconnect
the call,

-- Richard

-----Original Message-----
From: Ian Henderson [mailto:ianh@chime.net.au]
Sent: Saturday, April 09, 2005 5:20 AM
To: David Duncon
Cc: ccielab@groupstudy.com
Subject: Re: Voice Gateway Q

On Sat, 9 Apr 2005, David Duncon wrote:

> I was wondering , what is the best way/command to clear a "specific
> channel" on a Voice Gateway's PRI interface ? Cause I had an issue
> where I need to clear a specific channel which has a call happening
> since long time. So I tried the command "clear in ser1/0:9", but it did
> not do any thing.

Hvae you tried 'isdn disconnect interface Serial x y'?

--
Ian Henderson CCNA, CCNP
Senior Network Engineer
iiNet Limited
Chime Communications Pty Ltd

• Next message: Brian Dennis: "RE: multi parallel pvc's and bridging"
• Previous message: Daniel O'Sheedy: "Re: IE WB2: How to test Backup Interface?"
• Maybe in reply to: David Duncon: "Voice Gateway Q"
• Next in thread: David Duncon: "RE: Voice Gateway Q"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:54:55 GMT-3