From: Dave Mumford (Dave.Mumford@telindus.co.uk)
Date: Wed Feb 02 2005 - 13:31:29 GMT-3
Check to see if you have ip domain-lookup set at R2 , if so disable it.
Dave.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
John T M
Sent: 02 February 2005 16:17
To: ccielab@groupstudy.com
Subject: RSH and RCMD
I am trying the rsh for using it in TCL ping test. Somehow it is not
working. Here is what I am trying wit the two routers initially, the
loopbacks are reachable from either routers
R1(3640 with 12.3 ) ------> R2 ( 2621 with 12.3 )
R1 config has
interface lo 0
ip address 172.16.101.1 255.255.255.255
!
ip rcmd rsh-enable
ip rcmd source-interface loopback 0
R2 has
interface lo 0
ip address 172.16.105.1 255.255.255.255
!
ip rcmd rsh-enable
ip rcmd remote-host R1 172.16.101.1 R1 enable
!
When I try from R1 with command
rsh 172.16.105.1 show ip int brief
I get error %rcp protocol error.
Any clue on whats going wrong ?
Regds/John
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:16 GMT-3