From: Valdas Slimas (valdas.slimas@gmail.com)
Date: Mon Jan 24 2005 - 05:38:32 GMT-3
Jerry,
Yes, I have veryfied, its working fine for me on 3750ME, 6500, 10720
and GSR 4xGE card. GSR 3xGE card have problem, because port can work
only in l2 or l3 mode.
Have no equipment to check with Engine4+ GSR card.
regards,
On Sat, 22 Jan 2005 13:14:50 -0500, phase90 <phase90@comcast.net> wrote:
> Valdas,
>
> I know layer-2 & layer-3 can be done on the same blade
> because I've had this
> configuration with gigabit blade in a Catalyst 8540. Your issue may have to
> do with MPLS or you have a different blade that doesn't support it.
>
> Jerry
> ----- Original Message -----
> From: "Valdas Slimas" <valdas.slimas@gmail.com>
> To: "Casey Paul (IE)" <Paul.Casey@o2.com>
> Cc: <ccielab@groupstudy.com>
> Sent: Friday, January 21, 2005 8:43 AM
> Subject: Re: EOMPLS ????
>
> > Hi,
> >
> > >bla-pe-01(config)#interface GigabitEthernet2/3/0.10
> > >bla-pe-01(config-subif)#xconnect 10.160.160.9 10 encapsulation mpls
> > >Incompatible with ip address command on Gi2/3/0.10 - command rejected.
> > Could U please check, does ip address on subinterface is correct.
> >
> > > Is the point below in an issue ??? Is it saying we cant do layer3 and
> > > layer2 at the same time on the same card.
> > This restriction exist on 3GE (engine2) card, and removed on 4GE
> > (Engine3 or ISE) card. No idea about EPA-GE/FE-BBRD (Engine4+)
> >
> > /Valdas
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
-- /Valdas
This archive was generated by hypermail 2.1.4 : Wed Feb 02 2005 - 22:10:25 GMT-3