From: Larry Roberts (Groupstudy@american-hero.com)
Date: Wed Jan 19 2005 - 00:13:14 GMT-3
Here is the URL. It details what models support VLAN's as well as how
many each version supports.
You will need to do it in order as well.
1) Create the VLAN interface
interface ethenetX vlanY [logical|physical]
2) name the new interface and assign a security level
nameif vlanY NAME securityZ
3) give it an IP address
ip address NAME 1.1.1.1 255.255.255.0
For security reasons you should read up on when to configure an
interface as logical vs. physical
xuefei@bgctv.com.cn wrote:
> Hi guys,
>
> I connect 2 or 3 vlans to PIX internal interface
> and want to configure vlan trunking in PIX.
>
> Cisco site indicate to configure 'VLAN-based virtual
> interfaces'. But how to configuration is not provided.
> Does anybody did that job before?
>
> Btw, are there any hardware or software requirement
> to do that?
>
> Thanks in advance!
>
> Fei Xue
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Feb 02 2005 - 22:10:24 GMT-3