From: Bob Sinclair (bsin@cox.net)
Date: Sat Dec 04 2004 - 18:00:23 GMT-3
I suspect you have MTU differences. Try this command on each of the layer 3
interfaces: ip ospf mtu-ignore.
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427, CISSP
www.netmasterclass.net
----- Original Message -----
From: "R. Adjakou/Home" <radjakou@cfao.sn>
To: <ccielab@groupstudy.com>
Sent: Saturday, December 04, 2004 12:06 PM
Subject: OSPF over CRB
> Dear Group
> Why can't I get ospf work between R1 and R4.
> This is my diagram:
>
> R4-(S0)-----------(S0)-R2-(E0)-----------------(E0)R1
>
> I configure CRB on R2 and S0 and E0 are on the same bridge-group.
>
> R4 can ping R1's E0. R1 can ping R4's S0.
>
> -----------------------------------------
> R. Adjakou
> email: radjakou@cfao.sn
> -----------------------------------------
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jan 03 2005 - 10:31:24 GMT-3