From: rob (robnot@pacbell.net)
Date: Thu Dec 02 2004 - 13:22:00 GMT-3
The 'dot1x system-auth-control' (global command) is required on later
versions of OS I believe (earlier versions didn't need it).
The past is another country and they do things differently there!
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
gladston@br.ibm.com
Sent: Thursday, December 02, 2004 7:50 AM
To: ccielab@groupstudy.com
Subject: Dot1x
I have found examples of Dot1x that uses the global command "dot1x
system-auth-control" and other that do not use it. Any Comments?
(I am unable to test it - no 802.1x clients)
Here is an example that do not use the global command:
http://www.ciscopress.com/articles/article.asp?p=29600&seqNum=3
Cisco says:
If you have 802.1x configured on the switch and you upgrade to Cisco IOS
Release 12.1(14)EA1 or later, the configuration file will not contain the
new commands, and 802.1x will not operate. After the upgrade is complete,
make sure to globally enable 802.1x by using the dot1x system-auth-control
global configuration command.
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225se/3550scg/sw
8021x.htm
Is it a new requirement and some resources are not updated?
This archive was generated by hypermail 2.1.4 : Mon Jan 03 2005 - 10:31:23 GMT-3