From: ccie2be (ccie2be@nyc.rr.com)
Date: Thu Nov 25 2004 - 16:42:36 GMT-3
Could you post your config, please?
----- Original Message -----
From: <gladston@br.ibm.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, November 25, 2004 2:35 PM
Subject: MLP LFI and PQ
> Reading Wendell (great book, no doubts), table 7-10 'Comparisons between
MLP LFI and FRF-12' there is this statement:
> "... PQ most aggressively interleaves packets" -> for MLP LFI
>
> I could configure interleaving with MLP LFI using WFQ and CBWFQ. But when
trying to use PQ, it complains:
>
> r2#sh interfaces multilink 9
> Multilink9 is up, line protocol is up
> Hardware is multilink group interface
> Internet address is 172.16.25.2/24
> MTU 1500 bytes, BW 512 Kbit, DLY 100000 usec,
> reliability 255/255, txload 91/255, rxload 7/255
> Encapsulation PPP, loopback not set
> Keepalive set (10 sec)
> DTR is pulsed for 2 seconds on reset
> LCP Open, multilink Open
> Open: IPCP
> NOTE: Multilink interleaving is configured but inactive
> because queuing strategy is not fair-queueing
>
> Any Thoughts?
>
> (nice of the IOS give us a message, specially when this is so rare :))
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:50 GMT-3