From: ccie (ccie@gannons.net)
Date: Sun Oct 31 2004 - 12:57:18 GMT-3
If both peers are availble (no backup peer/cost) then use the redundancy.
Regards,
Kevin
>Hi All,
>
>I have a basic doubt about dlsw ethernet redundancy. I am trying to
>understand when we need to configure it? What i understand after
>reading the doc's its configured when one router has parallel
>connection to atleast two routers who are on same segment and
>SNA/NetBios is bridged between this router's attached segment and
>other router's LAN segment.
>
>However, i have seen many configurations where we don't enable dlsw
>ethernet redundancy. Some configurations i have seen which selects one
>as backup peer or we configure a cost so one is preferred over other.
>If i remember well i have some configs where its just left like that.
>My question whether all these configs are valid? when do we need to
>enable dlsw ethernet redundancy.
>
>Appreciate your comments. Thanks
>
>-AK
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:55 GMT-3