From: AK Singh (singh.anand@gmail.com)
Date: Sun Oct 31 2004 - 12:49:02 GMT-3
Hi All,
I have a basic doubt about dlsw ethernet redundancy. I am trying to
understand when we need to configure it? What i understand after
reading the doc's its configured when one router has parallel
connection to atleast two routers who are on same segment and
SNA/NetBios is bridged between this router's attached segment and
other router's LAN segment.
However, i have seen many configurations where we don't enable dlsw
ethernet redundancy. Some configurations i have seen which selects one
as backup peer or we configure a cost so one is preferred over other.
If i remember well i have some configs where its just left like that.
My question whether all these configs are valid? when do we need to
enable dlsw ethernet redundancy.
Appreciate your comments. Thanks
-AK
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:55 GMT-3