From: AZIZI Mounir (mounir.azizi@cegetel.fr)
Date: Fri Oct 22 2004 - 07:08:19 GMT-3
Hi All,
I'm using 12.2(13)T10, and would like to know why i have 2 Virtual-Access in
my "sh ip int brief" and not i my running config? why the first is up and
the second is down?
2611XM#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/0 1.1.1.1 YES TFTP up up
Serial0/0 unassigned YES TFTP up
up
Serial0/0.25 10.10.1.1 YES manual up up
BRI1/0 unassigned YES TFTP up
up
BRI1/0:1 unassigned YES unset down
down
BRI1/0:2 unassigned YES unset down
down
Virtual-Access1 unassigned YES unset up
up
Loopback0 192.168.1.1 YES TFTP up up
Dialer1 192.168.1.1 YES TFTP up
up
Virtual-Access2 unassigned YES unset down
down
2611XM#sh run int v1
Building configuration...
Current configuration : 61 bytes
!
interface Virtual-Access1
no ip address
ip mtu 1500
end
2611XM#sh run int v2
Building configuration...
Current configuration : 5 bytes
end
interface BRI1/0
no ip address
encapsulation ppp
dialer rotary-group 1
dialer-group 1
isdn switch-type basic-net3
no cdp enable
!
interface Dialer1
bandwidth 128
ip unnumbered Loopback0
encapsulation ppp
dialer in-band
dialer idle-timeout 90
dialer string XXXXXXXX
dialer-group 1
no cdp enable
ppp authentication chap callin
ppp chap hostname toto
ppp chap password toto
ppp multilink
ppp multilink links minimum 2
!
and what happen if i have 2 BRI interface and ppp multilink links minimum
set to 4 ?
Thanks for help,
Mounir AZIZI
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:51 GMT-3