From: Cisco Net (network.cisco@gmail.com)
Date: Sat Oct 16 2004 - 19:49:47 GMT-3
Hi
Clarification about the show ppp multilink command output on 2.5-28 section.
It was showed as the bundle showing 2 active participants.
On the solution guide both serial interfaces are associated with same
virtual-template interface (1). But show pp multink showing as 2 parti
cipants on the bundle which i am not able to see on my routers,
Rack1R3#sh pp mult
Multilink1, bundle name is Rack1R2
Bundle up for 00:34:32
0 lost fragments, 0 reordered, 0 unassigned
0 discarded, 0 lost received, 1/255 load
0x0 received sequence, 0x5 sent sequence
Member links: 1 active, 3 inactive (max not set, min not set)
Vi1, since 00:34:32, no frags rcvd, 375000 weight, 1496 frag size
--> Only one
Vt1 (inactive)
Vi2 (inactive)
Vt2 (inactive)
But when i configure each interface pointing to seperate Virtual
templates which make more sens,
Rack1R3#sh ppp mult
Multilink1, bundle name is Rack1R2
Bundle up for 00:02:36
0 lost fragments, 0 reordered, 0 unassigned
0 discarded, 0 lost received, 1/255 load
0x0 received sequence, 0x0 sent sequence
Member links: 2 active, 2 inactive (max not set, min not set)
Vi1, since 00:02:36, no frags rcvd, 375000 weight, 1496 frag size
Vi2, since 00:01:25, no frags rcvd, 375000 weight, 1496 frag size
Vt1 (inactive)
Vt2 (inactive)
I am not sure the expectation when we have 2 serials pointing to the
same virtual templats and solution guide showing 2 participants even
though the single virtual template used to associate from serial
interfaces.
Please verify if mine is wrong.
Reards
Cert
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:48 GMT-3