From: Cisco Net (network.cisco@gmail.com)
Date: Wed Oct 13 2004 - 03:23:22 GMT-3
I am not able to understand this second dialer interface concept.
Especialy since the main BRI interface is standby mode (back up) to
the fraimrelay interface.
Even if the interesting traffic (ICMP) hit on the new dialer
interface, how does the call will open when the bri interface is on
standby...
Please help me with this...
By the way my new dialer interface is not getting activated when i
ping the ip address on the other side (section 4.13)
R4:
interface Dialer100 --------------> Second interface for 4.13 secton
ip address 10.45.45.4 255.255.255.0
encapsulation ppp
dialer pool 1
dialer remote-name Rack1R5
dialer string 4370443
dialer-group 10
ppp authentication pap
ppp chap refuse
interface BRI3/0
no ip address
encapsulation ppp
load-interval 30
dialer pool-member 1
isdn switch-type basic-ni
isdn spid1 4082436155
ppp authentication chap pap
ppp pap sent-username Rack1R4 password 0 CISCO
ppp multilink
access-list 111 permit icmp host 10.45.45.4 host 10.45.45.5
dialer-list 10 protocol ip list 111
R5:
interface Dialer100 -------------> Second interface for 4.13 secton
ip address 10.45.45.5 255.255.255.0
encapsulation ppp
dialer pool 1
dialer remote-name Rack1R4
dialer-group 11
ppp authentication pap
ppp chap refuse
interface BRI2/0
no ip address
encapsulation ppp
dialer pool-member 1
isdn switch-type basic-ni
isdn spid1 4084370443
ppp authentication chap pap
ppp pap sent-username Rack1R4 password 0 CISCO
ppp multilink
access-list 111 permit icmp host 10.45.45.5 host 10.45.45.4
dialer-list 10 protocol ip list 111
Thank you
Cert.
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:47 GMT-3