From: Anand Singh (anandksi@cisco.com)
Date: Tue Oct 12 2004 - 11:35:20 GMT-3
Zafar,
Thanks for the reply. I understand the meaning but I am not sure if I loose
points if I configure one or other way. I verified with "csim sta xxx" and
both work fine. The questiion simply says "configure router to forward all
voip traffic to gateway".
Thanks
-Anand
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of Zafar Khan
> Sent: Monday, October 11, 2004 9:18 PM
> To: Anand Singh
> Cc: Campbell, Mark; ccielab@groupstudy.com
> Subject: Re: Forward all voip traffic to gateway
>
>
> Anand,
>
> http://cisco.com/en/US/products/sw/iosswrel/ps1835/products_co
> nfiguration_guide_chapter09186a0080080aec.html
>
> % Indicates that the preceding digit occurred zero or more
> times. This functions the same as the "*" used in regular expression.
>
> T Indicates the interdigit timeout. The router pauses to
> collect additional dialed digits.
>
>
> HTH
>
> Regards
> Zafar
>
>
>
> On Mon, 11 Oct 2004 08:49:15 -0700, Anand Singh
> <anandksi@cisco.com> wrote:
> > Mark,
> >
> > I forgot to mention that I tested and both of these command's work.
> >
> > -Anand
> >
> >
> >
> > > -----Original Message-----
> > > From: Campbell, Mark [mailto:campbell.mark@siemens.com]
> > > Sent: Monday, October 11, 2004 8:23 AM
> > > To: Anand Singh; ccielab@groupstudy.com
> > > Subject: RE: Forward all voip traffic to gateway
> > >
> > >
> > > Hi Anand,
> > >
> > > The best way test this would be to "debug dialpeer" and do "csim
> > > start (random number)" and see if there's a match to the dial-peer
> > > voice instance you used .% in...(otherwise just use your
> > > phone instead of
> > > csim.)
> > >
> > > Regards,
> > > Mark
> > >
> > > -----Original Message-----
> > > From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf
> > > Of Anand Singh
> > > Sent: Monday, October 11, 2004 4:22 PM
> > > To: ccielab@groupstudy.com
> > > Subject: Forward all voip traffic to gateway
> > >
> > > Hello All,
> > >
> > > If i have to configure router to forward all voip traffic to the
> > > voice gateway, can i use the following config:
> > >
> > > dial-peer voice 3 voip
> > > destination-pattern .%
> > > session target ipv4:3.3.3.3
> > > !
> > >
> > > What' the difference between this and using "destination-pattern
> > > .T". I know later will tell router to wait for interdigit timeout
> > > before placing the call but is both config valid for above
> > > requirement?
> > >
> > >
> > > Thanks
> > > -Anand
> > >
> > > ______________________________________________________________
> > > _________
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> ______________________________________________________________________
> > _
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________
> _________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:46 GMT-3