From: Capt.Spock (Capt.spock@gmail.com)
Date: Fri Oct 08 2004 - 15:50:55 GMT-3
Yes this fixed the issue.
Thanks to Hogo, Larry!
On Wed, 6 Oct 2004 15:32:49 -0400, Hogo, Trust <trust.hogo@sarcom.com> wrote:
> Try to configure your switch ports connected to dlsw routers with
> "switchport mode access" This should fix your problem.
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Capt.Spock
> Sent: Saturday, October 02, 2004 6:38 AM
> To: ccielab@groupstudy.com
> Subject: Need help in DLSW configuration in DOiT Sample Scenario.
>
> All, Need help in DLSW configuration in DOiT Sample Scenario.
>
> Section 11.3 says "The configuration should allow DLSW+ access to the
> Ethernet segments of all DLSW+ Peers".
>
> I used the below two commands..
> "dlsw bridge-group 1" is used in global configuration along with
> "bridge 1 protocol ieee" and "bridge-group-1" is entered in ethernet
> interface.
>
> The ethernet interfaces are routing BGP and as a result of bridging,
> routing functionality is lost.
>
> Appreciate if anybody can point out what am I missing?
>
> Thanks,
> Spock
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:45 GMT-3