Need help in DLSW configuration in DOiT Sample Scenario.

From: Capt.Spock (Capt.spock@gmail.com)
Date: Sat Oct 02 2004 - 08:38:19 GMT-3

• Next message: David Duncon: "RE: Matching Voice Signalling traffic"
• Previous message: Carlos G Mendioroz: "Re: matching pictures w/ mime"
• Next in thread: Capt.Spock: "Re: Need help in DLSW configuration in DOiT Sample Scenario."
• Maybe reply: Capt.Spock: "Re: Need help in DLSW configuration in DOiT Sample Scenario."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

All, Need help in DLSW configuration in DOiT Sample Scenario.

Section 11.3 says "The configuration should allow DLSW+ access to the
Ethernet segments of all DLSW+ Peers".

I used the below two commands..
"dlsw bridge-group 1" is used in global configuration along with
"bridge 1 protocol ieee" and "bridge-group-1" is entered in ethernet
interface.

The ethernet interfaces are routing BGP and as a result of bridging,
routing functionality is lost.

Appreciate if anybody can point out what am I missing?

Thanks,
Spock

• Next message: David Duncon: "RE: Matching Voice Signalling traffic"
• Previous message: Carlos G Mendioroz: "Re: matching pictures w/ mime"
• Next in thread: Capt.Spock: "Re: Need help in DLSW configuration in DOiT Sample Scenario."
• Maybe reply: Capt.Spock: "Re: Need help in DLSW configuration in DOiT Sample Scenario."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:42 GMT-3