From: sglzx (sglzx@163.com)
Date: Tue Sep 07 2004 - 12:16:29 GMT-3
it's success half .
Not for lost of the "multilink virtual-template 1" , just cause for the ios version.
The mlpofr/atm begins to work after i upgraded the ios of my router {from 12.1(24) to 12.1.5T.}
Till now the LFI doesn't work yet,i don't know why .
----- Original Message -----
From: "sglzx" <sglzx@163.com>
To: "Hao Zhong" <hao_zhong@yahoo.com>; <ccielab@groupstudy.com>
Sent: Tuesday, September 07, 2004 12:28 AM
Subject: Re: mlpofr/atm config problem
> Here is the cisco link about the configuration .
>
> http://www.cisco.com/en/US/tech/tk652/tk692/technologies_tech_note09186a00800b6098.shtml
>
> I did like that, but failed.
>
> ----- Original Message -----
> From: "Hao Zhong" <hao_zhong@yahoo.com>
> To: "sglzx" <sglzx@163.com>; <ccielab@groupstudy.com>
> Sent: Tuesday, September 07, 2004 12:10 AM
> Subject: Re: mlpofr/atm config problem
>
>
> >
> > You need to create a "interface multilink". Then under
> > "interface virtual-template", you need to add
> > "multi-group" command to associate it with the
> > multilink interface you created.
> >
> > Hao
> >
> > --- sglzx <sglzx@163.com> wrote:
> >
> > > Did anyone succeed configuring the MLPOFR /MLPOATM ?
> > > One of my customer dictate to use this method to
> > > carry Voice service.
> > > I do this in the lab environment ,the configuration
> > > same as cisco's website ,but it doesn't work.
> > > c7206+PA-A3-OC3MM-------ATM/FR(IWF)----C2611+2 V35
> > >
> > >
> > > C7206
> > > #sho ver
> > > Cisco Internetwork Operating System Software
> > > IOS (tm) 7200 Software (C7200-JS-M), Version
> > > 12.1(5)T1, RELEASE SOFTWARE (fc1)
> > > Copyright (c) 1986-2000 by cisco Systems, Inc.
> > > Compiled Sun 03-Dec-00 00:35 by ccai
> > > Image text-base: 0x60008960, data-base: 0x616F0000
> > >
> > > ROM: System Bootstrap, Version 12.0(19990210:195103)
> > > [12.0XE 105], DEVELOPMENT SOFTWARE
> > > BOOTFLASH: 7200 Software (C7200-BOOT-M), Version
> > > 12.0(4)T, RELEASE SOFTWARE (fc1)
> > >
> > > sz-test uptime is 6 hours, 55 minutes
> > > System returned to ROM by reload at 16:58:27 Peking
> > > Mon Sep 6 2004
> > > System restarted at 17:00:17 Peking Mon Sep 6 2004
> > > System image file is
> > > "slot0:c7200-js-mz.121-5.T1.bin"
> > >
> > > cisco 7206VXR (NPE300) processor (revision B) with
> > > 122880K/40960K bytes of memory.
> > > Processor board ID 13252175
> > > R7000 CPU at 262Mhz, Implementation 39, Rev 1.0,
> > > 256KB L2, 2048KB L3 Cache
> > > 6 slot VXR midplane, Version 2.0
> > >
> > > Last reset from power-on
> > > G.703/E1 software, Version 1.0.
> > > G.703/JT2 software, Version 1.0.
> > > Bridging software.
> > > X.25 software, Version 3.0.0.
> > > SuperLAT software (copyright 1990 by Meridian
> > > Technology Corp).
> > > TN3270 Emulation software.
> > > 2 FastEthernet/IEEE 802.3 interface(s)
> > > 12 Serial network interface(s)
> > > 1 ATM network interface(s)
> > > 125K bytes of non-volatile configuration memory.
> > >
> > > 20480K bytes of Flash PCMCIA card at slot 0 (Sector
> > > size 128K).
> > > 4096K bytes of Flash internal SIMM (Sector size
> > > 256K).
> > > Configuration register is 0x2102
> > >
> > > interface ATM6/0
> > > no ip address
> > > atm sonet stm-1
> > > no atm auto-configuration
> > > no atm ilmi-keepalive
> > > no atm address-registration
> > > !
> > > interface ATM6/0.1 point-to-point
> > > pvc 13/115
> > > vbr-nrt 2048 1024 36
> > > encapsulation aal5snap
> > > protocol ppp Virtual-Template1
> > > !
> > > --More-- !
> > > interface ATM6/0.2 point-to-point
> > > pvc 13/114
> > > vbr-nrt 2048 1024 36
> > > encapsulation aal5snap
> > > protocol ppp Virtual-Template1
> > > !
> > > !
> > > interface Virtual-Template1
> > > ip unnumbered Loopback0
> > > service-policy output atm-fr
> > > ppp multilink
> > > ppp multilink interleave
> > > no ppp multilink fragmentation
> > > !
> > >
> > >
> > > c2611:
> > > Router>en
> > > Router#sho ver
> > > Cisco Internetwork Operating System Software
> > > IOS (tm) C2600 Software (C2600-IS-M), Version
> > > 12.1(24), RELEASE SOFTWARE (fc2)
> > > Copyright (c) 1986-2004 by cisco Systems, Inc.
> > > Compiled Wed 12-May-04 04:45 by cmong
> > > Image text-base: 0x80008088, data-base: 0x80CDBB18
> > >
> > > ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE
> > > SOFTWARE (fc1)
> > >
> > > Router uptime is 17 minutes
> > > System returned to ROM by reload
> > > System image file is "flash:c2600-is-mz.121-24.bin"
> > >
> > > cisco 2611 (MPC860) processor (revision 0x203) with
> > > 26624K/6144K bytes of memory.
> > > Processor board ID JAD05220SNA (3880574384)
> > > M860 processor: part number 0, mask 49
> > > Bridging software.
> > > X.25 software, Version 3.0.0.
> > > 2 Ethernet/IEEE 802.3 interface(s)
> > > 2 Serial network interface(s)
> > > 32K bytes of non-volatile configuration memory.
> > > 8192K bytes of processor board System flash
> > > (Read/Write)
> > >
> > > Configuration register is 0x2102
> > >
> > >
> > >
> > > int s0/0
> > > no ip address
> > > encapsulation frame-relay IETF
> > > no ip mroute-cache
> > > no fair-queue
> > > --More-- frame-relay
> > > traffic-shaping
> > > frame-relay lmi-type ansi
> > > !
> > > interface Serial0/0.1 point-to-point
> > > frame-relay interface-dlci 113 ppp
> > > Virtual-Template1
> > > class test
> > > !
> > >
> > > interface Serial0/1
> > > no ip address
> > > encapsulation frame-relay IETF
> > > frame-relay lmi-type ansi
> > > !
> > > interface Serial0/1.1 point-to-point
> > > frame-relay interface-dlci 113 ppp
> > > Virtual-Template1
> > > class test
> > > !
> > > interface Virtual-Template1
> > > ip unnumbered Loopback0
> > > service-policy output fr-atm
> > > ppp multilink
> > > ppp multilink fragment-delay 10
> > > ppp multilink interleave
> > > !
> > >
> > >
> > > Router#sho ip int b
> > > Interface IP-Address OK?
> > > Method Status Protocol
> > > Ethernet0/0 unassigned YES NVRAM
> > > up down
> > > Serial0/0 unassigned YES NVRAM
> > > up up
> > > Serial0/0.1 unassigned YES unset
> > > up up
> > > Ethernet0/1 unassigned YES NVRAM
> > > administratively down down
> > > Serial0/1 unassigned YES NVRAM
> > > up up
> > > Serial0/1.1 unassigned YES unset
> > > up up
> > > Virtual-Access1 192.168.1.2 YES TFTP
> > > up down
> > > Virtual-Template1 192.168.1.2 YES TFTP
> > > down down
> > > Virtual-Access2 192.168.1.2 YES TFTP
> > > up down
> > > Loopback0 192.168.1.2 YES NVRAM
> > > up up
> > > Router#
> > >
> > >
> > >
> > >
> > > WHY ???
> > >
> > >
> > _______________________________________________________________________
> > > Please help support GroupStudy by purchasing your
> > > study materials from:
> > > http://shop.groupstudy.com
> > >
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> > >
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam? Yahoo! Mail has the best spam protection around
> > http://mail.yahoo.com
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:39 GMT-3