RE: protocol down

From: ccie (ccie@tisolutions.biz)
Date: Thu Sep 02 2004 - 08:43:08 GMT-3

• Next message: Cocimano, Francesco: "R: int vlan"
• Previous message: gladston@br.ibm.com: "NBAR - Discovering the Source"
• Maybe in reply to: ccie: "RE: protocol down"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all

It turned out to be a faulty WIC-1T

Thanks for the suggestions.

-----Original Message-----
From: Zachary Hinz [mailto:z_hinz@hotmail.com]
Sent: 01 September 2004 20:59
To: ccie
Subject: RE: protocol down

You need to define how many timeslots you are using.

service-module t1 timeslots xxxx
service-module t1 clock source internal/line

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/i
nter_r/irshowap.htm

----Original Message Follows----
From: "ccie" <ccie@tisolutions.biz>
Reply-To: "ccie" <ccie@tisolutions.biz>
To: <ccielab@groupstudy.com>
Subject: protocol down
Date: Tue, 31 Aug 2004 22:54:22 +0100

Hi All

I'm having a bit of a problem with a leased line between 2 sites. I
have
configured the serail interface as below:

site 1
serial 0/0

ip add 192.168.12.254 255.255.255.252
encaps ppp
bandwidth 1024
no shut

site 2

serial 0/0

ip add 192.168.12.253 255.255.255.252
encaps ppp
bandwidth 1024
no shut

Yet with this config I'm getting protocol down. Just wanted to check if
I
need to do anything else before I contact the service provider to test
the
line? Any ideas or suggestions would be appreciated.

TIA

Mark

• Next message: Cocimano, Francesco: "R: int vlan"
• Previous message: gladston@br.ibm.com: "NBAR - Discovering the Source"
• Maybe in reply to: ccie: "RE: protocol down"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:35 GMT-3