From: Scott Morris (swm@emanon.com)
Date: Sun Aug 22 2004 - 09:35:32 GMT-3
Hard to say about the reduction of points. But you need to ask yourself
exactly how many different ways SHOULD the line be brought up? If you are
using dialer-watch, and have it configured correctly, then logically that
will be the only way you need to dial.
On the exam, I'd say this would be the case!
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIP, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net <http://www.ipexpert.net/>
_____
From: mani poopal [mailto:mani_ccie@yahoo.com]
Sent: Sunday, August 22, 2004 1:25 AM
To: Scott Morris; 'Mathew'; 'CCIE LAB List'
Subject: RE: dialer-list command with dialer-watch config
Hi Scott,
So instead of "access-list 101 deny eigrp any any" can we use "access-list
101 deny ip any any" for dialer-watch for eigrp/isdn. What is the cisco
recommended method. Ciscopress Lab 1 says if we don't use "deny ip any any"
there is a reductiosn of points in the exam.
thanks
Mani
Scott Morris <swm@emanon.com> wrote:
Dialer-watch is the one thing that works independent of interesting traffic.
The fact that your route is down becomes "interesting" itself and your BRI
is brought up (providing you have the appropriate maps).
So if you are relying on dialer-watch, you do not need to have interesting
traffic.
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIP, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mathew
Sent: Saturday, August 21, 2004 9:54 PM
To: CCIE LAB List
Subject: dialer-list command with dialer-watch config
Hi,
In Karl Solie's Practical Studies book page 507 (chapter 7 under dialer
watch), he has used the below config;
access-list 101 deny eigrp any any
access-list 101 permit ip any any
dialer watch-list 1 ip 175.10.102.1 255.255.255.255 dialer watch-list 1 ip
175.10.1.0 255.255.255.0 dialer-list 1 protocol ip list 101
I use the same config with OSPF routing (1st line eigrp replaced with
ospf) and it worked.
Also when I used the below dialer-list command, then also it worked well.
dialer-list 1 protocol ip deny
Can some explain to me what is the difference? maybe I am missing something
in understanding the use of the "dialer-list" command with dialer watch.
mathew
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:47 GMT-3