From: gladston@br.ibm.com
Date: Wed Aug 18 2004 - 10:16:57 GMT-3
=========================
quoted
Typically it would not be necessary since VOFR is stricly L2. The bandwidth
command is only applicable to IGPs at L3. The port-speed only determines the
bandwidth at L2 unless you shape it with FRTS to a specified CIR.
=========================
The mentioned book says: "ensure you configure the command "fram-relay voice bandwidth otherwise your voice will not work"
Is it making a mistake?
These are similar configuration used on the example:
inter ser 0
frame-relay traffic-shaping
!
int ser 0.12 po
frame interface 12
class VOICE
vofr cisco
!
map-class frame-relay VOICE
frame voice bandwidth 64000
frame fragment
These is a similar configuration that I found:
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:45 GMT-3