From: john matijevic (matijevi@bellsouth.net)
Date: Thu Jul 29 2004 - 12:32:52 GMT-3
Richard,
According to page 305, practical studies vol1, ppp multilink is to bind
two 64kbps b channels together to for a single 128-kbps link. This is
also referenced in RFC 1990. To configure PPP multilink, use the
following commands on the interface or idaler on which you want to
configure PPP multilink:
ppp multilink
dialer load-threshold
The dialer load-threshold command specifies the interface load at which
the dialer intitiates another call to the destination.
That is how I understand it, and that is how I always configure it. I
have not seen an example of where dialer load-threshold is used and ppp
multilink is not, if there is please show me an example.
Sincerely,
John Matijevic, CCIE #13254, MCSE, CNE, CCEA
Network Consultant
Hablo Espanol
305-321-6232
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Richard Dumoulin
Sent: Thursday, July 29, 2004 11:21 AM
To: john matijevic; 'Joseph D. Phillips'; 'ccie2be'; 'Group Study'
Subject: RE: Dialer load threshhold vs. ppp multilink
John,
You can bring up the other channel (with the dialer load-threshold
command) without having ppp multilink enabled !
--Richard
-----Original Message-----
From: john matijevic [mailto:matijevi@bellsouth.net]
Sent: jueves, 29 de julio de 2004 17:18
To: 'Joseph D. Phillips'; 'ccie2be'; Richard Dumoulin; 'Group Study'
Subject: RE: Dialer load threshhold vs. ppp multilink
Hello Joseph,
Usually when you set dialer load-threshold, you want to also use ppp
multilink, otherwise whats the point of setting the load-threshold, if
you
cant bring up the other line.
Sincerely,
John Matijevic, CCIE #13254, MCSE, CNE, CCEA
Network Consultant
Hablo Espanol
305-321-6232
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joseph D. Phillips
Sent: Thursday, July 29, 2004 11:10 AM
To: ccie2be; Richard Dumoulin; Group Study
Subject: Dialer load threshhold vs. ppp multilink
Can someone explain what the difference is between dialer load-thresh
and
ppp multi? Are they mutually exclusive, if you have ppp configured
anyway?
This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:12:05 GMT-3