From: Andy Canizares (ccie@jzr.com)
Date: Mon Jun 14 2004 - 23:28:36 GMT-3
Art.
Enable the following commands on all routers:
ip rcmd rsh-enable
ip rcmd source-interface loop 0
ip rcmd remote-host R1 172.16.11.1 R1 enable
In the last command R1 is the Hostname of the router your executing the rsh
command from. The ip address in that command is the ip address of the
source routers loopback 0 interface.
-Andy
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Art
Lee
Sent: Monday, June 14, 2004 4:47 PM
To: ccielab@groupstudy.com
Subject: Tclsh & Rsh........
When I try to run a tclsh script with a rsh variable...I get a
"permission denied" reply back from all routers. I am assuming that I
will need to send the telnet password with the rsh command. Has any one
acomplished the ip reachability scripts that are posted here on Group
Study? And if so could you, briefly explain how to set this up.
Thanx
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:40 GMT-3