From: Edwards, Andrew M (andrew.m.edwards@boeing.com)
Date: Wed Jun 09 2004 - 19:45:43 GMT-3
You should be able to use either. Just depends upon how you want to
treat access to the legacy voice mail system... E.g. track access and
authorization or not.
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administra
tion_guide_chapter09186a00800c4cb9.html
This link should walk you through setting up SMDI (which runs over the
serial cable anyhow - OOB).
andy
-----Original Message-----
From: Hunt Lee [mailto:Hunt.Lee@telecom.co.nz]
Sent: Wednesday, June 09, 2004 3:11 PM
To: ccielab@groupstudy.com
Subject: Please help!!!
Would greatly appreciated if some can shed some light on this.
What signalling protocol should I use on my connection gateway in order
to fully support my customer's legacy voice mail system (running on SMDI
protocol)? Should I use MGCP or SCCP? Is there anything that I need to
look out for / consider in order to decide which path I should take?
Thanks,
Lee
------------------------------------------------------------------------
-----
-
"This communication, including any attachments, is confidential. If you
are not the intended recipient, you should not read it - please contact
me immediately, destroy it, and do not copy or use any part of this
communication or disclose anything about it. Thank you. Please note that
this communication does not designate an information system for the
purposes of the Electronic Transactions Act 2002."
------------------------------------------------------------------------
-----
-
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:36 GMT-3