From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Sat Jun 05 2004 - 08:37:33 GMT-3
You need the signaling pvc 0/5 qsaal !! I believe this like enabling ISDN
Q931. Although in ISDN it is automatically enabled,
--Richard
-----Original Message-----
From: Koen Peetermans [mailto:K.Peetermans@chello.be]
Sent: sabado, 05 de junio de 2004 10:32
To: ccielab@groupstudy.com
Subject: RE: ATM SVC's and ILMI
(Sorry, pressed "send" involuntarily)
Hi,
I am practicing ATM on the CCIE4U remote lab.
If you look in the Practical studies volume I book, Solie doesn't use ILMI
for bringing up SVC's. However, I don't seem to get my SVC's working unless
I enable the ILMI 0/16 pvc on the ATM main interface.
The configuration looks like this:
interface ATM0.99 multipoint
ip address 10.10.10.2 255.255.255.0
!
svc nsap 47.00918100000000E01E35FB01.000800080008.00
protocol ip 10.10.10.1 broadcast
!
atm nsap-address 47.00918100000000E01E35FB01.001200120012.00
I don't think there is anything wrong with the config since enabling ILMI
solves the problem.
Could there be a way for doing it without using ILMI (perhaps an ATM static
Route on the ATM switch ?)
Kind regards,
Koen.
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:33 GMT-3