From: Sergio Jimenez Arguedas (sejimenez@its.co.cr)
Date: Wed Jun 02 2004 - 20:11:49 GMT-3
Hi Group,
I have the following scenario:
R1-------ATM_NET----------R2
R1_Configuracisn:
interface ATM2/0.300 point-to-point
pvc 100/140
encapsulation aal5ciscoppp Virtual-Template1
protocol clns 49.0000.1010.1010.1010.00 broadcast
!
!
interface Virtual-Template1
ip address 10.1.1.1 255.255.255.0
ip router isis
R2_Configuracisn:
interface ATM2/0.200 point-to-point
pvc 100/140
encapsulation aal5ciscoppp Virtual-Template1
protocol clns 49.0000.1111.1111.1111.00 broadcast
!
!
interface Virtual-Template1
ip address 10.1.1.10 255.255.255.0
ip router isis
I can ping between each router, but the int virtual-template is DOWN.
OSPF,RIP,BGP,EIGRP are running perfectly but I don4t know what is happening
with the interface:
R1#sh int virtual-template 1
Virtual-Template1 is down, line protocol is down
Hardware is Virtual Template interface
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
LCP Closed
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:08:53
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Routing Protocols information:
R1#sh ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
10.10.10.10 1 FULL/ - 00:00:34 10.1.1.10
Virtual-Access1
R1#sh ip bgp summary
BGP router identifier 1.1.1.1, local AS number 1
BGP table version is 1, main routing table version 1
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down
State/PfxRcd
10.1.1.10 4 10 93 106 1 0 0 00:41:36 0
R1#sh ip eigrp neighbors
IP-EIGRP neighbors for process 100
H Address Interface Hold Uptime SRTT RTO Q Seq Type
(sec) (ms) Cnt Num
0 10.1.1.10 Vi1 11 00:21:30 220 1320 0 10
R1#sh clns neighbors
System Id Interface SNPA State Holdtime Type Protocol
R2 Vi1 *PPP* Up 26
L1L2 IS-IS
Can somebody help me, please? Is it a normal behavior?
Sergio
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:31 GMT-3