From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Wed Jun 02 2004 - 17:17:29 GMT-3
Hi Yasser, actually this is not what I asked. Mike provided two different
commands. One to be applied on an interface and another one to be applied
generally. So I wondered if both were required,
--Richard
-----Original Message-----
From: Yasser Abdullah [mailto:yasser@alharbitelecom.com]
Sent: miircoles, 02 de junio de 2004 21:11
To: Richard Dumoulin; 'Mike Schlenger'; pbubienczyk@szczesliwice.pl;
ccielab@groupstudy.com
Subject: RE: Voice - source/destinationa ddresses
I can't test this, but I think that if you want to control the source ip
when calls are 'originating' from either gateway, you need the command on
both ends.
Can someone test it?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Richard Dumoulin
Sent: Wednesday, June 02, 2004 5:02 PM
To: Mike Schlenger; pbubienczyk@szczesliwice.pl; ccielab@groupstudy.com
Subject: RE: Voice - source/destinationa ddresses
Hi Mike, should both commands be configured or one or the other ? The
doc-cd says it is convenient but it is not clear,
Thanks
--Richard
-----Original Message-----
From: Mike Schlenger [mailto:mschlenger@meridianitsolutions.com]
Sent: miircoles, 02 de junio de 2004 15:29
To: pbubienczyk@szczesliwice.pl; ccielab@groupstudy.com
Subject: RE: Voice - source/destinationa ddresses
Take a look at these commands under your loopback interfaces.
H323-gateway voip interface
H323-gateway voip bind srcad <in lo0>
Mike
Mike Schlenger
CCIE #7079
-----Original Message-----
From: pbubienczyk@szczesliwice.pl [mailto:pbubienczyk@szczesliwice.pl]
Sent: Wednesday, June 02, 2004 8:23 AM
To: ccielab@groupstudy.com
Subject: Voice - source/destinationa ddresses
Hello
My voip dial peers are configured with ip addresses of loopback
interfaces on both ends (with session target command). But the RTCP and RTP
communication is going with addresses of others interfaces (serial in this
particular case). Is there is some way to configure routers that all voice
communication will be held by using only loopback interfaces.
Thx for your help - Peter
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:31 GMT-3