From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Wed Jun 02 2004 - 11:01:57 GMT-3
Hi Mike, should both commands be configured or one or the other ? The
doc-cd says it is convenient but it is not clear,
Thanks
--Richard
-----Original Message-----
From: Mike Schlenger [mailto:mschlenger@meridianitsolutions.com]
Sent: miircoles, 02 de junio de 2004 15:29
To: pbubienczyk@szczesliwice.pl; ccielab@groupstudy.com
Subject: RE: Voice - source/destinationa ddresses
Take a look at these commands under your loopback interfaces.
H323-gateway voip interface
H323-gateway voip bind srcad <in lo0>
Mike
Mike Schlenger
CCIE #7079
-----Original Message-----
From: pbubienczyk@szczesliwice.pl [mailto:pbubienczyk@szczesliwice.pl]
Sent: Wednesday, June 02, 2004 8:23 AM
To: ccielab@groupstudy.com
Subject: Voice - source/destinationa ddresses
Hello
My voip dial peers are configured with ip addresses of loopback
interfaces
on both ends (with session target command). But the RTCP and RTP
communication
is going with addresses of others interfaces (serial in this particular
case).
Is there is some way to configure routers that all voice communication will
be
held by using only loopback interfaces.
Thx for your help - Peter
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:31 GMT-3