Ip pim autorp listener

From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Sun May 23 2004 - 06:33:53 GMT-3

• Next message: Kenneth Wygand: "RE: Quiz Question of the Day 20040520"
• Previous message: Ahmed Mustafa: "Shaping"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I am just realising that this command is hidden, at least in my ios !?!?
Anyone else ?

Rack1R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Rack1R1(config)#ip pim ?
  accept-register Registers accept filter
  accept-rp RP accept filter
  bidir-enable Enable Bidir-PIM
  bsr-candidate Candidate bootstrap router (candidate BSR)
  register-rate-limit Rate limit for PIM data registers
  register-source Source address for PIM Register
  rp-address PIM RP-address (Rendezvous Point)
  rp-announce-filter Auto-RP announce message filter
  rp-candidate To be a PIMv2 RP candidate
  send-rp-announce Auto-RP send RP announcement
  send-rp-discovery Auto-RP send RP discovery message (as RP-mapping
agent)
  spt-threshold Source-tree switching threshold
  ssm Configure Source Specific Multicast
  state-refresh PIM DM State-Refresh configuration
  vrf Select VPN Routing/Forwarding instance

Rack1R1(config)#ip pim autorp listener
Rack1R1(config)#
Rack1R1(config)#ip pim auto
% Incomplete command.

Rack1R1(config)#ip pim auto list
Rack1R1(config)#

• Next message: Kenneth Wygand: "RE: Quiz Question of the Day 20040520"
• Previous message: Ahmed Mustafa: "Shaping"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:15 GMT-3