From: Ahmed Mustafa (ahmed.mustafa@sbcglobal.net)
Date: Mon May 17 2004 - 14:49:15 GMT-3
Is it feasible to configure Dialer-Watch commands at the both ends of ISDN.
If the requirement is
Ether ISDN
Ethernet
RD
---------------------RA-------------------------------------------RB---------
-----------------------RC
RA and RB primary connection is Frame-Relay and the whole network is running
OSPF routing protocol.
If RA loses its connection to Frame-Relay or Ethernet or RB loses its
connection to Ethernet then the ISDN link should go up. I am confused between
either using ip ospf demand circuit on RA or dialer-watch at both ends.
Ahmed
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:13 GMT-3