RE: Dialer Watch Puzzle

From: Kenneth Wygand (KWygand@customonline.com)
Date: Sat May 15 2004 - 02:45:53 GMT-3


Vazman,
 
R5#
01:00:29: DDR: Dialer Watch: watch-group = 1
01:00:29: DDR: network 129.6.6.6/255.255.255.255 DOWN,
01:00:29: DDR: primary DOWN
01:00:29: DDR: Dialer Watch: Dial Reason: Primary of group 1 DOWN
01:00:29: DDR: Dialer Watch: watch-group = 1,
R5#
 
It appears as though your dialer watch configuration is working as it should. There is some other reason why the call is actually not being made. If you do a "show isdn status", are your circuits available? Can you post the output of "debug dialer events" or "debug dialer q931"? Dialer Watch is merely the trigger mechanism which your output shows is happening. I think your problem is with the call establishment.
 
HTH,
Ken

        -----Original Message-----
        From: nobody@groupstudy.com on behalf of Vazman@aol.com
        Sent: Sat 5/15/2004 1:00 AM
        To: ccielab@groupstudy.com
        Cc:
        Subject: Dialer Watch Puzzle
        
        

        Hello,
        
        I am working on a lab, which has R5 and R6 connected via a frame-relay link and isdn as backup. I have configured dialer-watch on R5 to watch the loopback on R6 (129.6.6.6/32). When I shut down the serial interface on R6, R5 DOES NOT trigger the call. I know my ISDN is working as I can ping the remote interface and bring the link up. Also, ran a debug dialer on R5 and it sees that the watched network is down but does not place the call. I think I have all the required config for dialer watch on R5 (dialer watch-group, dialer watch-list and the dialer map for the watched network). I also checked the network that I am watching via show ip route (see below)
        
        Any advice?
        
        Here is my config for R5 and R6 and output from debug dialer
        
        R5#
        01:00:29: DDR: Dialer Watch: watch-group = 1
        01:00:29: DDR: network 129.6.6.6/255.255.255.255 DOWN,
        01:00:29: DDR: primary DOWN
        01:00:29: DDR: Dialer Watch: Dial Reason: Primary of group 1 DOWN
        01:00:29: DDR: Dialer Watch: watch-group = 1,
        R5#
        
        R5#sir os
             129.3.0.0/32 is subnetted, 1 subnets
        O 129.3.3.3 [110/11] via 192.168.4.3, 01:10:24, Ethernet0
             129.6.0.0/32 is subnetted, 1 subnets
        O IA 129.6.6.6 [110/65] via 192.168.2.6, 00:00:18, Serial0.2
             129.13.0.0/32 is subnetted, 1 subnets
        O 129.13.13.13 [110/65] via 192.168.5.13, 00:00:18, Serial0.1
             62.0.0.0/24 is subnetted, 1 subnets
        O E2 62.9.1.0 [110/20] via 192.168.2.6, 00:00:18, Serial0.2
        R5#
        
        R5#sh run
        Building configuration...
        
        Current configuration : 2913 bytes
        !
        version 12.1
        no service single-slot-reload-enable
        service timestamps debug uptime
        service timestamps log uptime
        no service password-encryption
        !
        hostname R5
        !
        logging rate-limit console 10 except errors
        !
        username R6 password 0 cisco
        ip subnet-zero
        no ip finger
        no ip domain-lookup
        !
        isdn switch-type basic-ni
        cns event-service server
        !
        !
        !
        !
        !
        interface Loopback0
         ip address 129.5.5.5 255.255.255.0
        !
        interface Ethernet0
         ip address 192.168.4.5 255.255.255.0
        !
        interface Serial0
         no ip address
         encapsulation frame-relay
         no frame-relay inverse-arp
         frame-relay lmi-type cisco
        !
        interface Serial0.1 point-to-point
         ip address 192.168.5.5 255.255.255.240
         ip ospf message-digest-key 1 md5 cisco
         frame-relay interface-dlci 504
        !
        interface Serial0.2 point-to-point
         ip address 192.168.2.5 255.255.255.128
         ip ospf message-digest-key 1 md5 cisco
         frame-relay interface-dlci 506
        !
        interface Serial1
         no ip address
         shutdown
        !
        interface BRI0
         ip address 192.168.6.1 255.255.255.252
         encapsulation ppp
         dialer map ip 129.6.6.6 name R6 broadcast 4930622
         dialer map ip 129.6.6.6 name R6 broadcast 4930623
         dialer map ip 192.168.6.2 name R6 broadcast 4930622
         dialer map ip 192.168.6.2 name R6 broadcast 4930623
         dialer load-threshold 1 either
         dialer watch-group 1
         dialer-group 1
         isdn switch-type basic-ni
         isdn spid1 81049306240101 4930624
         isdn spid2 81049306250101 4930625
         ppp authentication chap
         ppp chap hostname cisco
         ppp chap password 7 00071A150754
         ppp multilink
        !
        router ospf 10
         router-id 129.5.5.5
         log-adjacency-changes
         area 0 authentication message-digest
         area 1 authentication message-digest
         area 1 virtual-link 129.6.6.6 message-digest-key 1 md5 cisco
         area 2 virtual-link 129.6.6.6 authentication message-digest
         area 2 virtual-link 129.6.6.6 message-digest-key 10 md5 cisco
         network 129.5.5.5 0.0.0.0 area 0
         network 192.168.2.5 0.0.0.0 area 1
         network 192.168.4.5 0.0.0.0 area 3
         network 192.168.5.5 0.0.0.0 area 0
         network 192.168.6.1 0.0.0.0 area 2
        !
        ip kerberos source-interface any
        ip classless
        no ip http server
        !
        access-list 175 deny ospf any any
        access-list 175 permit ip any any
        dialer watch-list 1 ip 129.6.6.6 255.255.255.255
        dialer-list 1 protocol ip list 175
        !
        alias configure ro router ospf
        alias configure re router eigrp
        alias configure rb router bgp
        alias configure ri router isis
        alias configure rr router rip
        alias exec siib show ip interface brief
        alias exec ct config term
        alias exec sr show run
        alias exec sion show ip ospf neighbor
        alias exec sir show ip route
        alias exec cir clear ip route *
        alias exec cib clear ip bgp *
        alias exec cior clear ip ospf redistribution
        alias exec sibs show ip bgp summary
        alias exec sib show ip bgp
        alias exec sien show ip eigrp neighbor
        !
        line con 0
         exec-timeout 0 0
         password cisco
         login
         transport input none
        line aux 0
        
        
        R6
        
        R6#sh run
        01:09:13: %SYS-5-CONFIG_I: Configured from console by console
        Building configuration...
        
        Current configuration : 2865 bytes
        !
        version 12.1
        no service single-slot-reload-enable
        service timestamps debug uptime
        service timestamps log uptime
        no service password-encryption
        !
        hostname R6
        !
        logging rate-limit console 10 except errors
        !
        username cisco password 0 cisco
        ip subnet-zero
        no ip finger
        no ip domain-lookup
        !
        isdn switch-type basic-ni
        !
        key chain RIP
         key 1
          key-string cisco
        cns event-service server
        !
        !
        !
        !
        !
        interface Loopback0
         ip address 129.6.6.6 255.255.255.0
        !
        interface Ethernet0
         ip address 62.9.1.6 255.255.255.0
         ip rip authentication mode md5
         ip rip authentication key-chain RIP
        !
        interface Serial0
         ip address 192.168.2.6 255.255.255.128
         encapsulation frame-relay
         ip ospf message-digest-key 1 md5 cisco
         ip ospf network point-to-point
         shutdown
         no fair-queue
         frame-relay map ip 192.168.2.5 605 broadcast
         no frame-relay inverse-arp
        !
        interface Serial1
         no ip address
        !
        interface BRI0
         ip address 192.168.6.2 255.255.255.252
         encapsulation ppp
         dialer map ip 192.168.6.1 name cisco broadcast
         dialer load-threshold 1 either
         dialer-group 1
         isdn switch-type basic-ni
         isdn spid1 81049306220101 4930622
         isdn spid2 81049306230101 4930623
         ppp authentication chap
         ppp multilink
        !
        router ospf 10
         router-id 129.6.6.6
         log-adjacency-changes
         area 0 authentication message-digest
         area 1 authentication message-digest
         area 1 virtual-link 129.5.5.5 message-digest-key 1 md5 cisco
         area 2 virtual-link 129.5.5.5 authentication message-digest
         area 2 virtual-link 129.5.5.5 message-digest-key 10 md5 cisco
         redistribute connected subnets route-map con2ospf
         network 129.6.6.6 0.0.0.0 area 4
         network 192.168.2.6 0.0.0.0 area 1
         network 192.168.6.2 0.0.0.0 area 2
        !
        router rip
         version 2
         redistribute ospf 10 metric 1
         passive-interface default
         no passive-interface Ethernet0
         offset-list SETHOP out 9
         network 62.0.0.0
         no auto-summary
        !
        ip kerberos source-interface any
        ip classless
        no ip http server
        !
        !
        ip access-list standard SETHOP
         permit 192.168.2.0 0.0.0.255
         permit 192.168.6.0 0.0.0.255
        access-list 175 deny ospf any any
        access-list 175 permit ip any any
        dialer-list 1 protocol ip list 175
        route-map con2ospf permit 10
         match interface Ethernet0
        !
        !
        alias configure ro router ospf
        alias configure re router eigrp
        alias configure rb router bgp
        alias configure ri router isis
        alias configure rr router rip
        alias exec siib show ip interface brief
        alias exec ct config term
        alias exec sr show run
        alias exec sion show ip ospf neighbor
        alias exec sir show ip route
        alias exec cir clear ip route *
        alias exec cib clear ip bgp *
        alias exec cior clear ip ospf redistribution
        alias exec sibs show ip bgp summary
        alias exec sib show ip bgp
        alias exec sien show ip eigrp neighbor
        !
        line con 0
         exec-timeout 0 0
         password cisco
         login
         transport input none
        line aux 0
         exec-timeout 0 0
         password cisco
         login
        line vty 0 4
         exec-timeout 0 0
         password cisco
         login
        !
        end
        
        R6#
        
        _______________________________________________________________________
        Please help support GroupStudy by purchasing your study materials from:
        http://shop.groupstudy.com
        
        Subscription information may be found at:
        http://www.groupstudy.com/list/CCIELab.html



This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:12 GMT-3