From: Mohamed (nmohamed@cisco.com)
Date: Fri May 14 2004 - 02:20:51 GMT-3
Hi,
I checked it worked!.
Here I don't know where is R6 ??
Ospf Ebgp
Up-------Down---------SFM
See you have a OSPF route in Down with some cost.
You have to run BGP in Down and redistribute ospf into BGP.
You will get a BGP route in Down.
The same route goes to SFM.
Now change the cost in loop 0
Down gets updated,BUT IT IS NOT SENDING TO SFM.
Pls chk again.
BTW-have you tried policy accounting ?
Thanks
Mohamed.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Sergio Jimenez Arguedas
Sent: Wednesday, May 12, 2004 9:42 PM
To: ccielab@groupstudy.com
Subject: BGP METRIC!!! SET METRIC-TYPE INTERNAL!!!
Hi Alvaro and Mohamed,
I read the explanation from Alvaro Retana, cisco!!!
I tested it and it works fine without the ROUTE-MAP with the set
metric-type internal!!!!
Scenario:
R1------------R2-------------------R3
R1 and R2 ospf and R2 y R3 eBGP.
R6#sh ip bgp
BGP table version is 2, local router ID is 192.168.20.1
Status codes: s suppressed, d damped, h history, * valid, > best, i -
internal Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 172.16.20.0/30 192.168.20.2 65 0 1 i
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:12 GMT-3