Can you have the "ip ospf demand-circuit" in both sides of a

From: Carlos Marchini (cmarchini@signetdiagnostic.com)
Date: Sat Apr 17 2004 - 18:26:20 GMT-3

• Next message: Amer Mdanat \(amdanat\): "RE: Can you have the "ip ospf demand-circuit" in both sides of"
• Previous message: Richard Dumoulin: "RE: Auto-RP vs BSR"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Can you have the "ip ospf demand-circuit" in both sides of a BRI link?
Books that I have read say that you are only supposed to have this command
in one side of the link and I was told the same thing in the ccbootcamp I
attended.

I found this document in Cisco site (Document 4808):

http://www.cisco.com/en/US/tech/tk365/tk480/technologies_tech_note09186a0080
09481b.shtml

This document claims that you can use the "ip ospf demand-circuit" in both
sides. Does this cause problems?

Also, is it good practice to include the "no peer neighbor-route" command in
the BRI interfaces to keep redistribution from bring up the bri links.

Thanks,
Carlos A. Marchini
Email - cmarchini@signetdiagnostic.com

• Next message: Amer Mdanat \(amdanat\): "RE: Can you have the "ip ospf demand-circuit" in both sides of"
• Previous message: Richard Dumoulin: "RE: Auto-RP vs BSR"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:49 GMT-3