From: Tom Young (gitsyoung@yahoo.co.jp)
Date: Wed Apr 14 2004 - 20:58:30 GMT-3
Adam
Thanks, you are right, I am doing the GSTACK gbics, for
two cat2950s, one interface(Half of a gbic) is amber lamp
on, maybe it is in spainning-tree block mode. And I
haven't do any config on these switchs. I don't know how
to operate the two switch as one, I couldn't find any
document for it.
For example, how to control other switchs if you on one
switch in the stack. And which command could be used for
checking stack status? Do you have some document about
these operation ?
Thanks alot
--- R&S Groupstudy <rsg@synergy-networking.co.uk> $B$+$i$N(B
$B%a%C%;!<%8!'(B
> Tom,
>
> Are you talking about the GSTACK gbics?
> If so there's no extra config to do mate.
> Note operation is at half duplex...... don't try and
> force it to full
>
> Adam
>
> !
> interface GigabitEthernet0/1
> switchport mode trunk
> !
> GigabitEthernet0/1 is up, line protocol is up
> Hardware is Gigabit Ethernet, address is
> 0006.53bd.1234 (bia
> 0006.53bd.1234)
> MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation ARPA, loopback not set
> Keepalive not set
> Auto-duplex (Half), 1000Mb/s, media type is
> CX_GIGASTACK
> output flow-control is off, input flow-control is
> off
> ARP type: ARPA, ARP Timeout 04:00:00
> GigaStack module(0.2) in GBIC slot. link1 is up,
> link2 is down
> Last input 00:00:00, output 00:00:00, output hang
> never
> Last clearing of "show interface" counters never
> Queueing strategy: fifo
> Output queue 0/40, 36 drops; input queue 0/75, 0
> drops
> 1 minute input rate 4374000 bits/sec, 921
> packets/sec
> 1 minute output rate 7000 bits/sec, 7 packets/sec
> 562407108 packets input, 536952525 bytes, 0 no
> buffer
> Received 448843709 broadcasts, 0 runts, 0
> giants, 0 throttles
> 375203 input errors, 0 CRC, 0 frame, 0 overrun,
> 0 ignored
> 0 watchdog, 278221541 multicast, 0 pause input
> 223611721 packets output, 2427157253 bytes, 0
> underruns
> 0 output errors, 42529 collisions, 1 interface
> resets
> 0 babbles, 0 late collision, 0 deferred
> 0 lost carrier, 0 no carrier, 0 pause output
> 0 output buffer failures, 0 output buffers
> swapped out
>
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com]On Behalf Of Tom
> Young
> Sent: 14 April 2004 16:44
> To: Marvin Greenlee
> Cc: ccielab@groupstudy.com
> Subject: Re: Cat2950G-48's stack config
>
>
> Marvin
>
> Thank you for replying, but I think the file you
> give me
> is not the stack document, it is the cluster
> setting.
> I am configing the Cat2950's stack now, but not
> successed. my switch is Cat4950G-48-EI, no problem
> with
> IOS, and memory, Special GBIC and cable is also ok,
> But
> couldn't done the stack, may I need some setting on
> switch
> ? How to confirm the stack status?
> And who can provide me some document about the
> stack
> config ?
>
> Thanks alot
> --- Marvin Greenlee <marvingreenlee@yahoo.com>
> $B$+$i$N%a(B
> $B%C%;!<%8!'(B
> > 2950 Clustering
> >
>
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12114ea1/2950scg
> /swclus.htm
> >
> > On the non-command switch, you need to configure
> the
> > command switch MAC-address and cluster name
> > ****
> > cluster commander-address 000d.bbbb.bbbb member 2
> > name
> > MYCLUSTER
> > <non-command switch>
> >
> > cluster enable MYCLUSTER 1
> > <Command Switch>
> > ****
> > In this example, the command switch is member 1
> and
> > the non-command switch is member 2.
> >
> > Or, you can use the CMS interface.
> >
> > Marvin Greenlee
> > Network Learning, Inc.
> > www.ccbootcamp.com
> >
> > --- Tom Young <gitsyoung@yahoo.co.jp> wrote:
> > > Hi , group
> > >
> > > Whould you please give me a config sample
> > about
> > > Cat2950G-48's stack ? I couldn't found anything
> > from
> > > cisco.com. And failured for making stack
> between
> > > cat2950s. Really need someone's help.
> > >
> > > Thanks alot
> >
> >
> >
> >
> > __________________________________
> > Do you Yahoo!?
> > Yahoo! Tax Center - File online by April 15th
> > http://taxes.yahoo.com/filing.html
>
> __________________________________________________
> Do You Yahoo!?
> http://bb.yahoo.co.jp/
>
>
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:47 GMT-3