Using policy-routing in MPLS

From: Kristof Ulrix (kristof@uk-systems.com)
Date: Fri Apr 09 2004 - 07:48:06 GMT-3

• Next message: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Previous message: William Lijewski: "RE: Internetworkexpert Lab 2 [bcc][faked-from]"
• Next in thread: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Maybe reply: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi group,

I would like to use policy-routing on vrf-interfaces,
but I get the following:

R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#int fa3/0
R1(config-if)#ip policy route-map Test
R1(config-if)#ip vrf forwarding Mgmt
% Remove Policy-Based Routing from interface FastEthernet3/0 first
R1(config-if)#no ip policy route-map Test
R1(config-if)#ip vrf forwarding Mgmt
R1(config-if)#

Is there another way to policy-route packets in a VRF?

Thanks in advance,

Kristof Ulrix.

• Next message: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Previous message: William Lijewski: "RE: Internetworkexpert Lab 2 [bcc][faked-from]"
• Next in thread: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Maybe reply: Richard Gallagher: "Re: Using policy-routing in MPLS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:44 GMT-3