From: Packet Man (ccie2b@hotmail.com)
Date: Sat Feb 28 2004 - 18:18:25 GMT-3
I can't answer your question, but I can tell you that this command is only
supported ( according to the documentation) on 7x00 series routers which
happen not to be used in the lab. So, if your interest in this command was
based on being prepared for the lab, you needn't be concerned. (That's when
I stopped spending time learning about this command.)
>From: "David Hurtado" <deivi78@hotmail.com>
>Reply-To: "David Hurtado" <deivi78@hotmail.com>
>To: ccielab@groupstudy.com
>Subject: Problems configuring bgp inject-map route-maps
>Date: Sat, 28 Feb 2004 19:42:05 +0000
>
>Today i was trying to configure "bgp inject-map" route-map and i had the
>following problem: Rack4R1(config-route-map)# set ip address prefix-list
>ORIGINATED
>wrong # args: should be "set varName ?newValue? Later i tried to set a
>community in a route-map, but i couldn't. It appeared on th screen:
> Rack4R4(config)#route-map atribuye permit 10
>Rack4R4(config-route-map)#set commun
>Rack4R4(config-route-map)#set community no-adve
>Rack4R4(config-route-map)#set community no-advertise
>no-advertise and when i tried to show what i was configured nothing
>appeared: Rack4R4#sh run | beg route-map
>route-map atribuye permit 10
>! I think taht the IOS was 12.2.15T5(ED). Could somebody explain to me
>why it didn't work, please? Thanks for the help
>
>------------------------------------------------------------------------
>
>?Estas pensando en cambiar de coche? Todas los modelos de serie y extras
>en MSN Motor.
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:59 GMT-3