From: Bob Sinclair (bsinclair@netmasterclass.net)
Date: Wed Feb 25 2004 - 21:12:45 GMT-3
Ahmed,
I believe that when redistributing INTO ISIS you need to add a metric
between 1 and 63 on the redistribute command. . By default it comes in with
metric 0 and acts like RIP or EGRP.
Bob Sinclair
CCIE #10427, CISSP, MCSE
www.netmasterclass.net
----- Original Message -----
From: "Ahmed Mustafa" <ahmed.mustafa@sbcglobal.net>
To: <ccielab@groupstudy.com>
Sent: Wednesday, February 25, 2004 7:01 PM
Subject: redistribute Loopbacks
> Is there anything other than simply use the following commands.
>
> R1 and R6 are connected via ISIS Level-1 only.
>
> on R6, I have a loopback interface 6 configured with 132.1.6.0/24, and I
> redistributed via redistributed connected method.
>
> r6
>
> router isis
> redistributed connected route-map connected2isis
>
>
> route-map connected2isis permit 10
> match interface loopback 6
>
> But the route will not appear on R1.
>
> Any advise !
>
> Regards,
>
> Ahmed
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:57 GMT-3